Airvent Systems designs complete air pollution control equipment, combining blowers, filters and scrubbers, to help industries meet environmental compliance norms.
We engineer complete emission control systems that combine the right blower, filtration or scrubbing technology, and ducting for your specific pollutant profile, helping your plant meet state and central pollution control board norms.
Request A Quote
Blower, filter/scrubber and ducting sized together as one system.
Built around your applicable emission limits.
Handles particulate, gaseous, and odour control needs.
Engineered to fit your existing plant footprint.
| Parameter | Range |
|---|---|
| System Type | Integrated blower, filter and scrubber |
| Emission Compliance | Designed to local regulatory norms |
| Capacity | Fully customized per plant requirement |
Ranges shown are indicative starting points, not a fixed catalog spec. Share your process data with our engineers for an exact recommendation and datasheet.
Gas composition, temperature and dust load determine the correct material. Common options for air pollution control equipment include:
Final material selection is confirmed based on your specific application, not a default.
Every unit follows the same engineering discipline, from duty point through to final testing.
Pollutant type, concentration and gas volume are characterized across your plant.
Blower, filtration and/or scrubbing stages are sequenced to match your emission profile.
Each stage, blower, dust collector, scrubber, is sized to the same duty point for compatibility.
Construction across all components is matched to the gas composition and temperature.
Ducting, dampers and controls are designed to tie the system together as one operating unit.
The complete system is checked for airflow and function before handover.
Combined dust and gas control across kiln and mill operations.
Multi-stage systems for particulate and gaseous pollutant control.
Emission control across furnace and material handling points.
Flue gas handling and particulate control systems.
Compliant process exhaust systems.
Emission control for dyeing and finishing processes.
It depends on your emission profile, but typically includes a blower or fan for airflow, a dust collector or bag filter for particulate, and/or a wet scrubber for gaseous pollutants, all sized to work together as one system rather than as separately selected components.
Dust collectors handle dry particulate. Wet scrubbers handle gaseous pollutants and can also capture particulate, especially sticky or hot particulate that would foul dry filter media. Many plants need both in sequence. Share your emission's composition and we can recommend the right combination.
We design systems around your process data and target emission level, and can advise on the expected performance range for a given configuration. Exact compliance verification against your local regulatory limit is typically confirmed through stack emission testing after installation.
We can support installation guidance and commissioning for systems we supply. Scope of on-site work is agreed at the order stage depending on your project's requirements.
Often yes, if the existing ducting and structure are in reasonable condition. Upgrading filtration media, adding a scrubber stage, or increasing blower capacity can extend a system's life and compliance headroom without a full replacement. Share your existing system details for an assessment.
